What should be paid attention to when using a irrigation machine?

The cutting machine is a two-stroke power system, and attention should be paid to three aspects during use: power, usage, and cutting tools to ensure the normal use of the machine: 1. Engine: A. Qualified gasoline and engine oil, ensuring their mixing ratio (25:1); B. Regularly (25 hours) check and replace the air filter, check the spark plug; C. After working on a box of oil, take a 10 minute break and clean the loose gasket of the machine to ensure heat dissipation; D. When storing, the body must be cleaned, the mixed fuel must be discharged, and the fuel in the vaporizer must be burned clean; Remove the spark plug, add 1-2ml of two-stroke engine oil to the cylinder, pull the starter 2-3 times, and install the spark plug. 2. Transmission: Regularly (25 hours) add lubricating grease to the gearbox, and also add lubricating grease to the joint between the upper part of the transmission shaft and the clutch disc. 3. Knife: The length of the nylon cable head should be controlled to be less than 15cm. When using a blade, the balance of the blade should be ensured, and vibrating blades should not be used.

The cutting machine is a two-stroke power system, and attention should be paid to three aspects during use: power, usage, and cutting tools to ensure the normal use of the machine:

1. Engine:

A. Qualified gasoline and engine oil, ensuring their mixing ratio (25:1);

B. Regularly (25 hours) check and replace the air filter, check the spark plug;

C. After working on a box of oil, take a 10 minute break and clean the loose gasket of the machine to ensure heat dissipation;

D. When storing, the body must be cleaned, the mixed fuel must be discharged, and the fuel in the vaporizer must be burned clean; Remove the spark plug, add 1-2ml of two-stroke engine oil to the cylinder, pull the starter 2-3 times, and install the spark plug.

2. Transmission: Regularly (25 hours) add lubricating grease to the gearbox, and also add lubricating grease to the joint between the upper part of the transmission shaft and the clutch disc.

3. Knife: The length of the nylon cable head should be controlled to be less than 15cm. When using a blade, the balance of the blade should be ensured, and vibrating blades should not be used.